Solitonic State in Microscopic Dynamic Failures

Onset of permanent deformation in crystalline materials under a sharp indenter tip is accompanied by nucleation and propagation of defects. By measuring the spatio-temporal strain field nearthe indenter tip during indentation tests, we demonstrate that the dynamic strain history at the moment of a displacement burst carries characteristics of formation and interaction of local excitations, or solitons. We show that dynamic propagation of multiple solitons is followed by a short time interval where the propagating fronts can accelerate suddenly. As a result of such abrupt local accelerations, duration of the fast-slip phase of a failure event is shortened. Our results show that formation and annihilation of solitons mediate the microscopic fast weakening phase, during which extreme acceleration and collision of solitons lead to non-Newtonian behavior and Lorentz contraction, i.e., shortening of solitons characteristic length. The results open new horizons for understanding dynamic material response during failure and, more generally, complexity of earthquake sources

XXXVI. A note on the measurement of the refractive index of liquids

n/

Rapid state purification protocols for a Cooper pair box

We propose techniques for implementing two different rapid state purification schemes, within the constraints present in a superconducting charge qubit system. Both schemes use a continuous measurement of charge (z) measurements, and seek to minimize the time required to purify the conditional state. Our methods are designed to make the purification process relatively insensitive to rotations about the x-axis, due to the Josephson tunnelling Hamiltonian. The first proposed method, based on the scheme of Jacobs [Phys. Rev. A 67, 030301(R) (2003)] uses the measurement results to control bias (z) pulses so as to rotate the Bloch vector onto the x-axis of the Bloch sphere. The second proposed method, based on the scheme of Wiseman and Ralph [New J. Phys. 8, 90 (2006)] uses a simple feedback protocol which tightly rotates the Bloch vector about an axis almost parallel with the measurement axis. We compare the performance of these and other techniques by a number of different measures.Comment: 14 pages, 14 figures. v2: Revised version after referee comments. Accepted for publication by Physical Review

Slatted pen floors reduce Salmonella in market swine held in abattoirs

The objective of this study was to directly compare Salmonella isolation rates from pig slaughtered after 4 hours holding on slatted or solid concrete floors. Seven truckloads (replicates) of market swine ( 120 kg) from a fully integrated farrow-to-slaughter operation were studied. At unloading, groups of pigs (15-30) were sorted to 1) no-hold (20-45 minutes waiting), 2) pens with solid concrete floors (4 hours), 3) slatted concrete floors (4 hours). Postmortem samples were cultured for Salmonella. Those pigs held in pens with slatted floors (63.6%) had significantly (P \u3c 0.05) less Salmonella in their ceca than those held on solid floors (72.7%)

Transport of NOX emissions from sugarcane fertilisation into the Great Barrier Reef Lagoon

The Great Barrier Reef World Heritage Area contains highly sensitive ecosystems that are threatened by the effects of anthropogenic activity including eutrophication. The nearby sugarcane plantations of tropical north Queensland are fertilised annually and there has been ongoing concern about the magnitude of the loss of applied nitrogen to the environment. Previous studies have considered the potential of rainwater run-off to deposit reactive nitrogen species into rivers and ultimately into the Great Barrier Reef Lagoon, but have neglected the possibility of transport via the atmosphere. This paper reports the results of a modelling study commissioned by Australia’s National Heritage Trust aimed at assessing whether or not atmospheric deposition of reactive nitrogen from Queensland’s sugarcane plantations posed a potential threat to the Great Barrier Reef Lagoon. Atmospheric dispersion modelling was undertaken using The Air Pollution Model, developed by Australia’s Commonwealth Scientific and Industrial Research Organisation. Despite the predominance of onshore southeasterly winds, the dispersion model results indicate that 9% of the time during the sugarcane fertilization season (in the modeled years 2001–2006) the meteorological conditions resulted in emissions from the coastal regions of north Queensland being transported out over the ocean around the Great Barrier Reef. The results suggest that there may be a greater efficiency for transport out over the reef during October than for November and December. For the 2 months that exhibited the greatest potential for transport of coastal pollution to the Great Barrier Reef, the modeled deposition of nitrogen oxides (NOX) into the Great Barrier Reef lagoon was less than 1% of the total emissions from the sugarcane plantations, but was not zero. Our model has a simple chemical scheme that does not cover the full chemistry of all reactive nitrogen compounds and so the results are only indicative of the potential levels of deposition. Nevertheless, our study shows that small amounts of NOX that originate from sugarcane fertilization may be transported and dry deposited into the Great Barrier Reef lagoon. Other pathways not included in the modeling scheme may provide a more efficient transport mechanism. Whilst modern practices for the application of fertilizer to sugarcane plantations have drastically reduced emissions, the potential efficiency of transport of pollutants via the atmosphere may be of concern for other more highly polluting agricultural industries

Derivation of tropospheric methane from TCCON CH₄ and HF total column observations

The Total Carbon Column Observing Network (TCCON) is a global ground-based network of Fourier transform spectrometers that produce precise measurements of column-averaged dry-air mole fractions of atmospheric methane (CH₄). Temporal variability in the total column of CH₄ due to stratospheric dynamics obscures fluctuations and trends driven by tropospheric transport and local surface fluxes that are critical for understanding CH₄ sources and sinks. We reduce the contribution of stratospheric variability from the total column average by subtracting an estimate of the stratospheric CH₄ derived from simultaneous measurements of hydrogen fluoride (HF). HF provides a proxy for stratospheric CH₄ because it is strongly correlated to CH₄ in the stratosphere, has an accurately known tropospheric abundance (of zero), and is measured at most TCCON stations. The stratospheric partial column of CH₄ is calculated as a function of the zonal and annual trends in the relationship between CH₄ and HF in the stratosphere, which we determine from ACE-FTS satellite data. We also explicitly take into account the CH₄ column averaging kernel to estimate the contribution of stratospheric CH₄ to the total column. The resulting tropospheric CH₄ columns are consistent with in situ aircraft measurements and augment existing observations in the troposphere

Magnetic anisotropies and general on--site Coulomb interactions in the cuprates

This paper derives the anisotropic superexchange interactions from a Hubbard model for excitations within the copper 3d band and the oxygen 2p band of the undoped insulating cuprates. We extend the recent calculation of Yildirim et al. [Phys. Rev. B {\bf VV}, pp, 1995] in order to include the most general on--site Coulomb interactions (including those which involve more than two orbitals) when two holes occupy the same site. Our general results apply when the oxygen ions surrounding the copper ions form an octahedron which has tetragonal symmetry (but may be rotated as in lanthanum cuprate). For the tetragonal cuprates we obtain an easy--plane anisotropy in good agreement with experimental values. We predict the magnitude of the small in--plane anisoComment: 25 pages, revte

Atmospheric greenhouse gases retrieved from SCIAMACHY: comparison to ground-based FTS measurements and model results

SCIAMACHY onboard ENVISAT (launched in 2002) enables the retrieval of global long-term column-averaged dry air mole fractions of the two most important anthropogenic greenhouse gases carbon dioxide and methane (denoted XCO_2 and XCH_4). In order to assess the quality of the greenhouse gas data obtained with the recently introduced v2 of the scientific retrieval algorithm WFM-DOAS, we present validations with ground-based Fourier Transform Spectrometer (FTS) measurements and comparisons with model results at eight Total Carbon Column Observing Network (TCCON) sites providing realistic error estimates of the satellite data. Such validation is a prerequisite to assess the suitability of data sets for their use in inverse modelling. It is shown that there are generally no significant differences between the carbon dioxide annual increases of SCIAMACHY and the assimilation system CarbonTracker (2.00 ± 0.16 ppm yr^(−1) compared to 1.94 ± 0.03 ppm yr−1 on global average). The XCO_2 seasonal cycle amplitudes derived from SCIAMACHY are typically larger than those from TCCON which are in turn larger than those from CarbonTracker. The absolute values of the northern hemispheric TCCON seasonal cycle amplitudes are closer to SCIAMACHY than to CarbonTracker and the corresponding differences are not significant when compared with SCIAMACHY, whereas they can be significant for a subset of the analysed TCCON sites when compared with CarbonTracker. At Darwin we find discrepancies of the seasonal cycle derived from SCIAMACHY compared to the other data sets which can probably be ascribed to occurrences of undetected thin clouds. Based on the comparison with the reference data, we conclude that the carbon dioxide data set can be characterised by a regional relative precision (mean standard deviation of the differences) of about 2.2 ppm and a relative accuracy (standard deviation of the mean differences) of 1.1–1.2 ppm for monthly average composites within a radius of 500 km. For methane, prior to November 2005, the regional relative precision amounts to 12 ppb and the relative accuracy is about 3 ppb for monthly composite averages within the same radius. The loss of some spectral detector pixels results in a degradation of performance thereafter in the spectral range currently used for the methane column retrieval. This leads to larger scatter and lower XCH_4 values are retrieved in the tropics for the subsequent time period degrading the relative accuracy. As a result, the overall relative precision is estimated to be 17 ppb and the relative accuracy is in the range of about 10–20 ppb for monthly averages within a radius of 500 km. The derived estimates show that the SCIAMACHY XCH_4 data set before November 2005 is suitable for regional source/sink determination and regional-scale flux uncertainty reduction via inverse modelling worldwide. In addition, the XCO2 monthly data potentially provide valuable information in continental regions, where there is sparse sampling by surface flask measurements

Total column CO_2 measurements at Darwin, Australia – site description and calibration against in situ aircraft profiles

An automated Fourier Transform Spectroscopic (FTS) solar observatory was established in Darwin, Australia in August 2005. The laboratory is part of the Total Carbon Column Observing Network, and measures atmospheric column abundances of CO_2 and O_2 and other gases. Measured CO_2 columns were calibrated against integrated aircraft profiles obtained during the TWP-ICE campaign in January–February 2006, and show good agreement with calibrations for a similar instrument in Park Falls, Wisconsin. A clear-sky low airmass relative precision of 0.1% is demonstrated in the CO2 and O2 retrieved column-averaged volume mixing ratios. The 1% negative bias in the FTS X_(CO_2) relative to the World Meteorological Organization (WMO) calibrated in situ scale is within the uncertainties of the NIR spectroscopy and analysis